~Delete 37428

For standard epoxy and polish fiber optic connectors, the termination method typically contains 7 steps (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes based on your fiber) fiber cladding

two. Clean the exposed bare fiber with isopropyl alcohol and lint-cost-free wipes

three. Insert the bare fiber into the connector center hole till ...

The termination procedure for industry normal epoxy and polish fiber optic connectors.

For regular epoxy and polish fiber optic connectors, the termination method typically contains 7 steps (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes based on your fiber) fiber cladding

2. Clean the exposed bare fiber with isopropyl alcohol and lint-cost-free wipes

3. Insert the bare fiber into the connector center hole until the fiber stops

4. Inject fiber optic epoxy with a syringe dispenser into the connector body

5. Remedy the fiber optic epoxy with high temperature which could be 85C, 100C or even 120C based on the sort of fiber optic epoxy(you need to have a particular connector epoxy curing oven for this purpose)

6. Scribe the fiber protruding from the tip of the fiber connector

7. Polish the connector tip with lapping films either by hand or specialized fiber optic connector polishing machine(specifically for single mode fiber connectors)

So you see that the approach for terminating optical fiber is a complex procedure. It takes time and practice and only very trained fiber optic technicians can do the function appropriately with high yield ratio.

But fiber optic contractor installers for premise networks typically do not have the luxury of time or the costly tools for this type of termination. And that is when speedy termination fiber optic connectors come into handy.

Speedy termination fiber optic connectors are specially designed for fast termination without lots of expertise needed. A fiber optic contractor installer can do a speedy termination inside 2~three minutes.

There are several distinct designs but the typical 1 such as Corning Siecor cisco ccna Unicam connector is like this:

The Unicam connector is pre-polished in factory with a fiber stub hidden inside the body of the connector. The installer then only requirements 5 actions to total a Unicam connector termination with market standard high quality.

1. Strip the optical fiber to expose the 125um fiber cladding

2. Clean the exposed bare fiber with isopropyl alcohol and lint-free of charge wipes

3. Cleave the fiber with a cleaver

four. Insert the fiber into the Unicam connector till it stops

five. Crimp the fiber onto the Unicam connector with a fiber connector crimper tool

A fiber optic contractor installer can make a Unicam connector termination inside 2 minutes. Compared to the regular epoxy approach (up to 30 minutes), that is 87% time saved.

Unicam connectors provide equivalent insertion loss performance as a common epoxy and polish connector. Unicam connectors also meet or exceed the mechanical and optical overall performance specified by EIA/TIA 568.B.

Fiber Optic For security [http://www.calarttech.com/cisco/cisco-certified-network-associate-ccna ccna training training] Sale Co stocks all kinds of Corning Siecor Unicam connectors such as Unicam ST, TKT Unicam CTS SF, Corning TKT Unicam, Unicam LC, Unicam SC, Unicam tool kit and TKT Unicam Elite.